10/5/2023 0 Comments Hp spectre x360 15 ch011dxLift up the display panel assembly and separate it from the top case. Un-route the display panel cable from the right side. Un-route the speaker cable and the webcam cable from the left side. Open the display panel 270 degrees and remove four screws securing the display panel hinges. Remove one screw securing the DC-IN power jack and pull the DC jack cable from the case Here’s the other side of the motherboard. Separate the motherboard from the top case assembly. Remove three screws attaching the motherboard to the top case assembly. Lift up and remove the display cable from the connector.ĭisconnect the following color coded cables from the motherboard:ĭon’t forget to unlock all connector before removing the cables. Lift up the locking tab securing the cable inside the connector (red arrow). Here’s how to disconnect the display cable. The display panel cable is located very close to the laptop case and you’ll have very limited space to work. Motherboard removalĬarefully disconnect both antenna cables from the wireless card.ĭisconnect the left rear speaker cable (yellow) and the webcam cable (green) from the motherboard.ĭisconnect the DC power jack cable (red), the display panel cable (green) and the right rear speaker cable (green) from the motherboard. All these boards are secured by one screw and can be easily removed. I don’t show how to remove them but it shouldn’t be difficult. ![]() – Headphones jack board (called audio board in the service manual). You will find a few small boards attached to the top case assembly: Remove one screw securing the PCIe NVMe M.2 solid state drive. ![]() Lift up and remove the USB power button board with the I/O cable attached. Lift up the locking tab securing the cable inside the connector (red arrow) and pull the cable out. Remove one screw securing the USB power button board and disconnect the I/O cable from the motherboard. Lift up and remove the right cooling fan. Remove two screws and disconnect the fan cable from the motherboard. Un-route both cables from the guided path on the side of the fan. While removing the fan you’ll have to un-route the left front speaker cable from the guided path on the side of the fan.ĭisconnect the audio board cable (red) and the right front speaker cable (yellow) from the motherboard. The cooling fan cable connector plugs/unplugs vertically. Grab the cables as close to the connector as possible using needle-nose tweeters and lift it up. Remove two screws securing the left cooling fan and disconnect the fan cable from the motherboard. Now you can access both memory slots on the motherboard and replace or upgrade RAM modules if necessary. Carefully pull the mylar sheet up to separate the metal cover from the clamps (yellow ovals) on the motherboard. There is a metal RAM cover under the mylar sheet which is attached to the sheet with adhesive. I looked at other sources and I think upgrading it to 32GB (2x16GB) shouldn’t be a problem. According to Crucial website HP Spectre x360 15-ch can handle 16GB (2x8GB) DDR4-2400 SODIMM modules. RAM modules removalīoth memory (RAM) modules are located under the black mylar sheet. HP Spectre x360 15-ch series battery type: YB06XL. ![]() Lift up the battery and disconnect the battery cable from the motherboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |